There is also more visual appeal for the original footrest system: replacement pedals were made for the gearshift and foot brake lever which cut a good figure not only because of their coordinated design. Due to their length they are also much easier to operate than the originals. The pillion pegs can also be replaced with those from the southern German manufacturer. They are coated with ribbed rubber so that they match the design of the grips. On the other hand, they prevent the feet from slipping off in wet conditions.

If a more comfortable seat with more legroom is important to the companion, a lowering kit including detents can be mounted on both sides to the existing mounting points of the pillion detents. This changes the position of the feet by about 90 mm forwards and about 60 mm downwards. The ends of the detents are supplied in the ‚Crown‘ design, the same as it is available for the grips.

Those who wish a slimmer solution for the rear, can swap the bulky turn signal/tail light combination, the lighting unit and the number plate holder for the new alternative from WUNDERKIND-Custom which blends harmoniously with the course of the fender: A plain license plate holder in two different design versions which both coordinate with the design of the other parts. With integrated number plate illumination, LED brake/rear light and turn signals. A matching rear reflector is offered as a supplement.

As usual, all accessories have been developed in-house, manufactured from high-quality materials and tested internally to ensure the highest quality and safety standards. All custom parts comply with the German StVO or have a homologation paper.

Further information: WUNDERKIND-Custom.com